If you don't re-install the washer with the bolt, it will very likely leak. When removing the drain plug, be careful not to lose the sealing washer. The drain plug is located on the bottom of the tank. The first thing you need to do is drain the oil tank. This is great because it prevents dirt/dust from getting all over the inside of the funnel when it's not in use, so you don't have to clean it every time before you use it. It has covers that screw onto each end of the funnel. My personal favorite for a funnel to use is the NAPA 'clean funnel' (NAPA part number 720-1087). A long nose funnel is recommended to make refilling the oil tank easier. You will also need something to drain the oil into. I prefer to use a torque wrench to tighten drain plugs, as it prevents over-tightening them. You will need 8mm, 12mm and 14mm sockets, and extension, and a ratchet. The first thing you need to do is gather a few hand tools. Has it been a while since you have taken your 400EX to the shop for an oil and filter change? Tired of paying outrageous dealer prices to have it done? Read on to find out how you can change your own oil and filter, save money, and perhaps have a bit of fun in the process.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |